Speaker Chair Project.

[No Mercy]

I currently have 4 x 3w (8 ohm) speakers and 2 x 5w subwoofers (8ohms)
The idea was to have the four speakers at the top half of the chair and the two 'woofers on the bottom.
I just need help wiring them up. I currently have NO amp and I was hoping to make it portable and possibly battery driven (no main power cable)
If anyone could help me search for a amp below $50 (on the sites below) and maybe a wiring diagram, it would be greatly appreciated.

www.jaycar.com.au
www.dicksmith.com.au

 

[SiloHunter]

http://search.jaycar.com.au/search?w=amp&view=list
http://search.dicksmith.com.au/search#w=amp
http://lmgtfy.com/?q=how+to+wire+speakers+into+a+chair

 

[No Mercy]

http://search.jaycar.com.au/search?w=amp&view=list
http://search.dicksmith.com.au/search#w=amp
http://lmgtfy.com/?q=how+to+wire+speakers+into+a+chair

I'm asking about the power specifically, I have the design for the chair.

 

[No Mercy]

Bump.

 

[Pugsport]

id just use a car amp to run them

one two channel amp for the speakers and one mono block amp for the subs

 

[DamageINC]

I just wouldn't make a speaker chair in the first place.

 

[No Mercy]

Well, its for a school project. No going back now. Thanks Pug Ill have to get one soon, Cheers.

 

[No Mercy]

Update 1: http://www.youtube.com/watch?v=D-eLS1MkYjA

 

[No Mercy]

I started again on the chair today. I will be posting alot of photos :
The four tweeters are in place in the top half of the chair
That "stain" is from a rag I used to clean them

Cut out the hole for the sub under the main seat.

Took out foam from around the hole and filled with spray foam.

Screwed the subs into the hole, filled the outer edges with more spray foam.
Screwed down the components and amp too

Chair needs some more finishing touches before its finished

I will post a photo once everything is finished

 

[Sodalover]

Very cool.